Procurement & Supply Chain

Lower cost on the parts you already buy

We link your purchase history to your part master and BOMs. You see what each part costs, who supplies it, which machines use it and where the same part is bought twice.

Take the 3-minute procurement self-assessment

MachineA-100C-200F-300A-101A-102C-201C-202F-301F-302Supplier ASupplier BSupplier CSupplier DSingle sourceMACHINEASSEMBLYPARTSUPPLIER

What we usually find

01

One part, three prices

The same bearing is bought under four numbers at three prices.

02

A long supplier tail

Half the suppliers deliver a few percent of spend, and each needs a contract.

03

Unmapped single sources

A controller board has one supplier, and nobody knows which machines it stops.

04

Full shelves, missing part

Shelves of slow movers, while service waits for the one missing part.

Spend per part, linked to the machines

A spend cube tied to your BOMs shows which parts drive cost, which suppliers you could drop and where one supplier feeds many machines.

  • Top suppliers and the long tail side by side
  • Spend per part and per supplier
  • A flag wherever one supplier feeds many machines
SPEND BY SUPPLIER10 of 14 suppliers · 18% of spendTop 4 suppliers: 82% of spend

Example with made-up numbers. Your figures come from the programme.

What we look at

Spend cube and categories

Spend by category, supplier and part, including tail spend and should-cost checks.

Supplier risk at BOM level

Single- and sole-source parts, mapped to the machines and customers they affect.

Stock

Slow-moving and obsolete stock, and the trade-off between service level and working capital.

Make or buy

A cost comparison for parts and assemblies you could make in-house or buy in.

Standard parts

Equivalent parts across product families, so you buy fewer variants in larger volumes.

Procurement Savings Programme

4–6 weeks, fixed scope and price. It usually follows the Parts Data Check.

What you get

  • Spend cube by category, supplier and part
  • Shortlist of suppliers to consolidate
  • Single-source risk map, linked to your BOMs
  • Slow-moving and obsolete stock with its value
  • A savings estimate per category, with the assumptions written out

What we need from you

  • 12–24 months of purchase history (ERP export)
  • Part master and current BOMs
  • Stock levels per site
  • Two or three short calls with purchasing and logistics

Week 1

Data in

We take your exports, check them and agree the scope. If the data cannot support the analysis, we say so and you can stop here.

Weeks 2–4

Analysis

Spend cube, supplier risk and stock analysis.

Week 5

Findings workshop

We walk your team through the results and the savings case.

After

Your call

You decide what to act on. We can help, or your team takes it from there.

Questions we often get

Do you need access to our ERP?

No. Standard exports from SAP or any other ERP are enough. We never need write access.

How do you handle prices and supplier data?

Under NDA, on EU-hosted systems. You decide what happens to the data when the project ends.

Do you negotiate with suppliers?

No. Your buyers get the facts and the shortlist, and the negotiation stays with them.

Our data is messy.

Most part masters are. Duplicates and missing classes are part of what the programme cleans up.

How do you count savings?

We set a baseline from your purchase history before any change. Savings are measured against it in your purchase prices afterwards.

Send us one purchase export

In a 30-minute call we look at it with you and tell you what we see.